Line Location

The Line Location of a figure can be altered by accessing the Stroke Panel. This panel can be opened in one of the following ways:

1. Press on the Stroke Button located in the Drawing Toolbar.

   

   

2. Press on the Info Button in Top Toolbar to open the Info Menu.

   

   Then press on the Strokeoption to open the Stroke Panel.

   

   

To alter the Line Cap Type:

1. Enable the Stroke Visibility option (if disabled) by tapping on the On/Off toggle in the upper right corner of the Stroke Panel.

   

   

2. Press on the desired Line Location option.

   

3. To close the Stroke Panel, tap on the Hide Sidebar Button located at the bottom of the sidebar panel.

   

4. The example below shows what a Rectangle looks like when each Line Location choice is selected: Center, Inside, and Outside.

   

Note: A line location change will be seen instantaneously when a stroke figure is selected. If no figures have been selected, the line join change will apply to all subsequently created stroke figures.

---